![]() ![]() You can clean the excess hair from your blades by using a small brush or worn out toothbrush. Always replace broken or nicked blades to prevent injury. Spray lubricants contain insufficient oil for good lubrication, but are an excellent clipper blade coolant. Wipe excess oil off blades with a soft dry cloth. Place a few drops of Andis Clipper Oil on the front and side of the cutter blades (Figure G). The clipper should be held in the position shown in Figure F to prevent oil from getting into the motor. If your clipper blades leave streaks or slow down, it's a sure sign blades need oil. CARE AND SERVICING OF YOUR ANDIS CLIPPER BLADESīlades should be oiled before, during, and after each use. If you have a detachable blade unit, you can change your blade in order to maintain a comfortable temperature using multiple blades of the same size is popular among groomers. If blades are too hot, dip the blades only into Andis Blade Care Plus or apply Andis Cool Care Plus and then Andis Clipper Oil. ![]() To replace or change your blade set, slide the blade bracket onto the hinge of the clipper (Figure E) and with the clipper running, push the blade towards the clipper to lock into position.ĭue to the high speed nature of Andis clippers, please check for blade heat often, especially on close cutting blades. ![]() If this hap pens, you can clean out the hair by brushing out the cavity with a small brush or an old toothbrush while the blade is off the clipper (see Figure D for location of cavity being referenced). NOTE: Hair may accumulate in the front cavity of the housing under the blade. If your blade hinge should snap closed and is flush with the clipper, use a small standard screw driver to pry the tongue of the hinge out (Figure D). To remove blade set, first make sure your clipper motor is switched off, then push down on blade with both thumbs (Figure C) and slide blade off blade hinge. If the supply cord is damaged it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. Other than the recommended maintenance described in this manual, no other maintenance should be performed, except by Andis Company or an Andis Authorized Service Station. The internal mechanism of your clipper has been permanently lubricated at the factory. Different blade angles in relation to the skin, thickness and texture of the hair will vary the cutting length.Ĭleaning and user maintenance shall not be made by children without supervision. Use the chart below to find the approximate lengths of cut. The length of trim is indicated on each attachment comb. The attachment combs help guide the hair to the blades and give you precise control of hair lengths. To attach a comb, slip the attachment onto top edge of blade and snap down onto bottom edge of blade (Figures A & B). The attachment combs are easy to use–they snap on and off. You can set the blades for a longer cut by using any of the attachment combs made for your Andis clipper. (Some models do not have attachment combs) Andis MBG-2 - Eas圜lip Groom Detachable Blade Clipper Manual ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |